09-26-2019, 07:21 PM
In the current majority of users are only concerned with the Stone Quarrying Process Line Philippines production and use, paying less attention to the cleaning work of the impact crusher, sometimes inevitable in the production process such problems, so that the user is in a passive state, so that it can not be broken The machine continues to be put into production. When cleaning the impact crusher, the first thing to pay attention to is the safety problem. The power must be disconnected before cleaning can be done. Then open the inside of the crushing chamber, clear the remaining material, and then clean the residual material on the hammer. When cleaning the impact crusher, use a cleaning tool such as a brush or a towel to avoid injury. After cleaning the material, clean it with 75% ethanol and then close the crushing chamber. At this point, the interior has been cleaned, the rest is to clean the appearance of the impact crusher, the ground is also cleaned. After this is done, then boot up and see if there are any errors.
Before preparing to use and start up, check whether the internal parts of the fuselage are firmly installed, loose or not, and there are no oil stains on the belt and pulley. Wipe clean with a clean rag in time, do not leave any stains and dust. . Whether there is any residue left over from the feed port and the discharge port should be treated in time to ensure that the discharge port and the feed port are clean and tidy. At the same time, it is necessary to see if there are any other debris in the crushing chamber of the equipment, and also clean it up in time.
Before preparing to use and start up, check whether the internal parts of the fuselage are firmly installed, loose or not, and there are no oil stains on the belt and pulley. Wipe clean with a clean rag in time, do not leave any stains and dust. . Whether there is any residue left over from the feed port and the discharge port should be treated in time to ensure that the discharge port and the feed port are clean and tidy. At the same time, it is necessary to see if there are any other debris in the crushing chamber of the equipment, and also clean it up in time.
